All Products 22270
- Taper Bush : 4040
- Shaft Diameter Range : 55 - 100 mm
- Pitch Diameter : 560 mm
- Outside Diameter : 567 mm
- Groove : 8
- Type of belt : H
- Pitch : 12700 mm
- Pitch diameter : 136.08 mm
- Outside diameter + flange: 142 mm
- Teeth : 34
- Type of bush : 2012; max bore : 50 mm
- Belt width : 2.00 inch
- Type of pulley : 4
- Material : Cast iron
- Flange : With flanges
.png)
- Taper Bush : 3020
- Shaft Diameter Range : 25 - 75 mm
- Pitch Diameter : 236 mm
- Outside Diameter : 241.6 mm
- Groove : 4
- TOP DRIVE® HTD belt is an evolution of standard positive drive belts. The tooth shape is the HTD profile according to ISO 13050.
- This profile has been used for many years in a wide range of applications and it is well known for its outstanding performances. Power transmission is much higher compared to the classic inch trapezodial profile.
- The circular-arc tooth provides superior tooth jump resistance and provides a smooth tooth engagement. The noise level is remarkably reduced if compared to the classic trapezodial belts.
- How to measure the size of a product :
- For example, CHD1064-8M20
- - 1640 = pitch length (mm)
- - 8M = pitch
- - 20 = belt width (mm)
%20(1).png)
- Taper Bush : 5050
- Shaft Diameter Range : 70 - 125 mm
- Pitch Diameter : 800 mm
- Outside Diameter : 809.6 mm
- Groove : 6
Properties:
- Economical design
- Concentrically machined
- Vibration damping
- Electrically isolating
- Press fit design
- Low backlash, due to keyway connection
Material :
Coupling hub: up to series 450 high strength alumunium, series 800 and up steel
Elastomer insert: precision molded, wear resistant, and thermally stable polymer.
Idler Sprockets : Ball bearing idler sprocket have sealed ball bearing with extended inner race and setscrews for securing to shaft.
Ready Sprockets : An assortment of sprockets and hubs drilled and tapped for simple, convertient assembly with standard hex head cap screws.
Finished Bore Sprockets : No. 35 through No. 80 with standard keyway and setscrew. Many sizes stocked both with and without induction hardened teeth.
Dimensions in milimeters:
Keyways are British Standard Metric B S 4235. Part 1: 1972 DIN 6885 and conform to ISO recomendations with the exception of those marked, which are shallower. Where a key is to be used it should be parallel and side fitting, with top clearance. Depth of keyway is measured at the CENTRE
